<hardware, communications> A device used to connect a modem to a telephone line via an ordinary handset. The acoustic coupler converts electrical signals from the modem to sound via a loudspeaker, against which the mouthpiece of a telephone handset is placed. The earpiece is placed against a microphone which converts sound to electrical signals which return to the modem. The handset is inserted into a sound-proof box containing the louspeaker and microphone to avoid interference from ambient noise. Acousitic couplers are now rarely used since most modems have a direct electrical connection to the telephone line. This avoids the signal degradation caused by conversion to and from audio. Direct connection is not always possible, and was actually illegal in the United Kingdom before {British Telecom} was privatised. BT's predecessor, the General Post Office, did not allow subscribers to connect their own equipment to the telephone line. (1994-11-08)

<protocol> A modem standard developed by Rockwell for 56 kbps communications. K56flex Became more popular than the rival X2 but will be superseded by the official V.90 standard. [Already superseded?] (1998-09-08)

MOdulator DEModulator

A modulator-demodulator or modem is a computer hardware device that converts data from a digital format into a format suitable for an analog transmission medium such as telephone or radio. A modem transmits data by modulating one or more carrier wave signals to encode digital information, while the receiver demodulates the signal to recreate the original digital information.

(modems)

<hardware, communications> (Modulator/demodulator) An electronic device for converting between serial data (typically EIA-232) from a computer and an audio signal suitable for transmission over a telephone line connected to another modem. In one scheme the audio signal is composed of silence (no data) or one of two frequencies representing zero and one. Modems are distinguished primarily by the maximum data rate they support. Data rates can range from 75 bits per second up to 56000 and beyond. Data from the user (i.e. flowing from the local terminal or computer via the modem to the telephone line) is sometimes at a lower rate than the other direction, on the assumption that the user cannot type more than a few characters per second. Various data compression and error correction algorithms are required to support the highest speeds. Other optional features are auto-dial (auto-call) and auto-answer which allow the computer to initiate and accept calls without human intervention. Most modern modems support a number of different protocols, and two modems, when first connected, will automatically negotiate to find a common protocol (this process may be audible through the modem or computer's loudspeakers). Some modem protocols allow the two modems to renegotiate ("retrain") if the initial choice of data rate is too high and gives too many transmission errors. A modem may either be internal (connected to the computer's bus) or external ("stand-alone", connected to one of the computer's serial ports). The actual speed of transmission in characters per second depends not just the modem-to-modem data rate, but also on the speed with which the processor can transfer data to and from the modem, the kind of compression used and whether the data is compressed by the processor or the modem, the amount of noise on the telephone line (which causes retransmissions), the serial character format (typically 8N1: one start bit, eight data bits, no parity, one stop bit). See also acoustic coupler, adaptive answering, {baud barf}, Bulletin Board System, Caller ID, SoftModem, U.S. Robotics, UUCP, whalesong. Usenet newsgroup: news:comp.dcom.modems. (2002-05-04)

Acoustic shock is the set of symptoms a person may experience after hearing an unexpected, loud sound. The loud sound, called an acoustic incident, can be caused by feedback oscillation, fax tones, or signalling tones.

Acoustic microscopy is microscopy that employs very high or ultra high frequency ultrasound. Acoustic microscopes operate non-destructively and penetrate most solid materials to make visible images of internal features, including defects such as cracks, delaminations and voids.